Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Precision 7960 Tower Service Manual

Installing the external M.2 2280 solid-state drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the external M.2 2280 solid-state drive and provide a visual representation of the installation procedure.

Installing the solid-state drive hard-drive assembly

Steps

  1. Align the notch on the solid-state drive with the tab on the solid-state drive connector.
  2. Insert the solid-state drive at a 45-degree angle into the slot on the solid-state drive assembly.
  3. Place the cover over the solid-state drive assembly.
  4. Install the single (M3x6) screw and the two (M3x3) screws to secure the cover to the solid-state drive assembly.

Next steps

  1. Follow the procedure in After working inside your computer.

  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\