Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Precision 7960 Tower Service Manual

PDF

Installing the rear SATA/SAS module

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the rear SATA/SAS module and provide a visual representation of the installation procedure.

Installing the rear SATA/SAS module

Steps

  1. Align the screw holes on the rear SATA/SAS module with the screw holes on the flex4.
  2. Place the rear SATA/SAS module into the slot in the flex4.
  3. Install the two screws (6-32) to secure the rear SATA/SAS module to the flex4.
  4. Connect the data cable to the connector on the SATA/SAS board.
  5. Connect the power cable to the connector on the SATA/SAS board.
  6. Connect the thermal-sensor cables and fan-controller cables to the connectors on the power-distribution board.
    NOTE:Follow the same procedure from step 1 to step 6, to install the SATA/SAS module in flex3.

Next steps

  1. Install the right-side cover.
  2. Install the rear 3.5-inch hard-drive assembly.
  3. Install the rear 2.5-inch hard-drive assembly.
  4. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\