Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Precision 7960 Tower Service Manual

PDF

Installing the front I/O-board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the front I/O-board and provide a visual representation of the installation procedure.

Installing the front I/O-board

Steps

  1. Slide and place the front I/O-board in to the front I/O-bracket.
  2. Align the screw holes on the front I/O-board with the screw holes on the front I/O-bracket.
  3. Replace the three (6-32) screws to secure the front I/O-board with the front I/O-bracket
  4. Position the front I/O-bracket to align the tabs on the bracket with the slots on the chassis.
  5. Push in and tighten the thumb screw to secure the front I/O bracket to the chassis.
  6. Connect all the cables to the connectors on the front I/O-board.

Next steps

  1. Install the front system-fan assembly.
  2. Install the PCIe holder.
  3. Install the front optical-drive and hard-drive inner bezel.
  4. Install the air shroud.
  5. Install the right-side cover.
  6. Install the front I/O-bezel.
  7. Install the top cover.
  8. Install the front optical-drive and hard-drive bezel.
  9. Install the front bezel.
  10. Install the left-side cover.
  11. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\