Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Configure Static Routes for the Management Interface

When an IP address that a protocol uses and a static management route exists for the same prefix, the protocol route takes precedence over the static management route.

To configure a static route for the management port, use the following command.
Assign a static route to point to the management interface or forwarding router. CONFIGURATION mode management route ip-address mask { forwarding-router-address | ManagementEthernet slot/port}

Example of the show ip route static Command

To view the configured static routes for the management port, use the show ip management-route command in EXEC privilege mode. 
Dell#show ip management-route all
                                 
                                 Destination    Gateway                State
                                 -----------    -------                -----
                                 1.1.1.0/24     172.31.1.250           Active
                                 172.16.1.0/24  172.31.1.250           Active
                                 172.31.1.0/24  ManagementEthernet 1/0 Connected
                                 
                                 Dell#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\