Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Managing ECMP Group Paths

Configure the maximum number of paths for an ECMP route that the L3 CAM can hold to avoid path degeneration.

When you do not configure the maximum number of routes, the CAM can hold a maximum ECMP per route.

To configure the maximum number of paths, use the following command.

  • NOTE: Save the new ECMP settings to the startup-config ( write-mem) then reload the system for the new settings to take effect.
  • Configure the maximum number of paths per ECMP group. CONFIGURATION mode. ip ecmp-group maximum-paths { 2-64}
  • Enable ECMP group path management. CONFIGURATION mode. ip ecmp-group path-fallback

Example of the ip ecmp-group maximum-paths Command 

Dell(conf)#ip ecmp-group maximum-paths 3
                                 User configuration has been changed. Save the configuration and reload to take effect
                                 Dell(conf)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\