- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Dell G3 15 3500
- Base cover
- Memory module
- Solid-state drive—M.2 slot one
- Solid-state drive—M.2 slot two
- Hard drive
- Left fan
- Right fan
- Battery
- Wireless card
- Speakers
- Coin-cell battery
- Power-adapter port
- Heat sink
- I/O board
- Display assembly
- System board
- Power button with fingerprint reader
- Touchpad
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Dell G3 15 3500 Service Manual
Installing the battery
Prerequisites
If your are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Steps
- Place the battery on the palm-rest and keyboard assembly.
- Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
- Replace the three screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
- Connect the battery cable to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\