Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell G3 15 3500 Service Manual

PDF

Installing the touchpad

Prerequisites

If your are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.

Image: Installing the touchpad

Steps

  1. Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
  2. Replace the four (M2x2) screws and adhere the tape that secures the touchpad to the palm-rest and keyboard assembly.
  3. Align and place the touchpad bracket into the slot on the palm-rest and keyboard assembly.
  4. Replace the three (M2x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.

Next steps

  1. Install the system board.
  2. Install the power-adapter port.
  3. Install the heat sink.
  4. Install the left fan.
  5. Install the right fan.
  6. Install the coin-cell battery.
  7. Install the battery.
  8. Install the solid-state drive in M.2 slot two.
  9. Install the solid-state drive in M.2 slot one.
  10. Install the WLAN card.
  11. Install the memory module.
  12. Install the base cover.
  13. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\