Dell EMC OpenManage Enterprise Power Manager Version 2.0 User’s Guide

Create a device discovery job

1. Launch OpenManage Enterprise and click Monitor > Discovery > Create.
   The Create Discovery Job dialog box is displayed.
2. In the Create Discovery Job dialog box, a default job name is populated. To change it, enter the discovery job name.

   By default, the dialog box enables you to define properties of similar devices at a time.

   • To include more devices or ranges to the current discovery job, click Add. Another set of the following fields is displayed where you can specify the device properties: Type, IP/Hostname/Range, and Settings.
     WARNING A maximum of 8,000 devices can be managed by OpenManage Enterprise. Hence, do not specify large networks that have devices more than the maximum number of devices supported by OpenManage Enterprise. It may cause the system to abruptly stop responding.
     NOTE When discovering a large number of devices, avoid creating multiple discovery jobs using individual IP address and instead use IP range of the devices.
3. From the Device Type drop-down menu, to discover:
   • A server, select SERVER. See Specifying discovery mode for creating a server discovery job section in OpenManage Enterprise User's Guide.
   • A chassis, select CHASSIS. See Specifying discovery mode for creating a chassis discovery job section in OpenManage Enterprise User's Guide.
   • A Dell EMC storage device, or network switch, select DELL STORAGE, or NETWORKING SWITCH. See Specifying discovery mode for creating a storage, Dell storage, and network switch discovery job section in OpenManage Enterprise User's Guide.
   • A Power Distribution Unit (PDU) device, select PDU.
     NOTE Only after installing or enabling Power Manager you can view the PDU device type option.
   • To discover various devices by using multiple protocols, select MULTIPLE.
4. In the IP/Hostname/Range box, enter the IP address, hostname, or the range of IP address to be discovered or included. For more information about the data you can enter in this field, click the i symbol.
   NOTE

   • The range size is limited to 16,385 (0x4001).
   • IPv6 and IPv6 CIDR formats are supported.
5. In the Settings section, enter the username and password of the protocol that is used for discovering the ranges.
6. Click Additional Settings, to select a different protocol, and change the settings.
   NOTE Ensure you select the SNMP protocol to discover PDU devices.
7. In the Scheduling Discovery Job section, run the job immediately or schedule for a later point of time. See Schedule job field definitions.
8. Select the Email when complete check box, and then enter the email address that must receive notification about the discovery job status. If the email is not configured, the Go to SMTP Settings link is displayed. Click the link, and configure the SMTP settings. If you select this but do not configure SMTP, the Finish button is not displayed to continue the task.
9. Click Finish. The Finish button is not displayed if the fields are incorrectly or incompletely filled.
   A discovery job is created and run. The status is displayed on the Job Details page.