To restore the devices or groups to their normal state, disable the Emergency Power Reduction (EPR).
About this task
NOTE If you are logging in as a Device Manager, only the device groups and devices that are in your scope are available for viewing and management.
For example, if you are logging in as a Device Manager DM1 user, you can disable only the EPRs that Device Manager DM1 user has applied, and on the devices and groups that Device Manager DM1 user has access to.
NOTE An EPR activated due to a temperature-triggered event cannot be disabled manually. After the temperature reduces to the normal value,
Power Manager automatically removes the EPR.
To disable a manually applied EPR, perform the following steps:
Steps
Launch OpenManage Enterprise, and then click
Plugins > Power Management > Emergency Power Reduction.
Select the devices or groups, and click
Disable.
On the confirmation page, click
Yes.
EPR is disabled successfully.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\