Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug ip bgp updates

Allows you to view information about BGP updates.

Syntax

debug ip bgp [ ipv6-address | peer-group peer-group-name | ipv6 unicast [ ipv6-address]] updates [in | out | prefix-list prefix-list-name]

To disable debugging, use the no debug ip bgp [ ip-address | peer-group peer-group-name | ipv6 unicast [ ipv6-address]] updates [in | out] command.

Parameters

ipv6-address	(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prefix length in the /x format. The range is from /0 to /128. NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group peer-group-name	(OPTIONAL) Enter the keywords `peer-group` then the name of the peer group.
ipv6 unicast [ ipv6-address]	(OPTIONAL) Enter the keywords `ipv6 unicast`, and, optionally, an ipv6 address.
in	(OPTIONAL) Enter the keyword `in` to view only BGP updates received from neighbors.
out	(OPTIONAL) Enter the keyword `out` to view only BGP updates sent to neighbors.

Command Modes

EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

Entering a no debug ip bgp command removes all configured debug commands for BGP.