Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug vrrp ipv6

Allows you to enable debugging of VRRP.

Syntax debug vrrp ipv6 interface [ vrid] {all | packets | state | timer}
Parameters
interface Enter the following keywords and slot/port or number information:
  • For a Port Channel interface, enter the keywords port-channel then a number.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
  • For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
packets Enter the keyword packets to enable debugging of VRRP control packets.
state Enter the keyword state to enable debugging of VRRP state changes
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If no options are specified, debug is active on all interfaces and all VRRP groups.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\