- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the memory modules
- Replacing the memory modules
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the hard drive
- Replacing the hard drive
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the wireless card
- Replacing the wireless card
- Removing the rear cover
- Replacing the rear cover
- Removing the computer base
- Replacing the computer base
- Removing the status-light board
- Replacing the status-light board
- Removing the speakers
- Replacing the speakers
- Removing the system board
- Replacing the system board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the heat sink
- Replacing the heat sink
- Removing the fans
- Replacing the fans
- Removing the power-button board
- Replacing the power-button board
- Removing the fingerprint-reader board
- Replacing the fingerprint-reader board
- Removing the touchpad
- Replacing the touchpad
- Removing the display assembly
- Replacing the display assembly
- Removing the palm rest
- Replacing the palm rest
- Removing the keyboard
- Replacing the keyboard
- Removing the display bezel
- Replacing the display bezel
- Removing the display hinges
- Replacing the display hinges
- Removing the display panel
- Replacing the display panel
- Removing the display cable
- Replacing the display cable
- Removing the camera
- Replacing the camera
- Removing the display back-cover and antenna assembly
- Replacing the display back-cover and antenna assembly
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 15 7000 Gaming Service Manual
Procedure
- Align the screw holes on the power-button board with the screw holes on the palm-rest assembly.
- Replace the two screws (M2x3) that secure the power-button board to the palm-rest assembly.
- Adhere the power-button board cable to the palm-rest assembly.
- Slide the fingerprint-reader board cable into the connector on the fingerprint-reader board and close the latch to secure the cable.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\