Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Alienware Aurora R11 Service Manual

Installing the front I/O-panel

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the front I/O-panel and provide a visual representation of the installation procedure.

Image: Installing the front I/O-panel

Steps

  1. Align the screw holes on the front I/O-panel with the screw holes on the front bezel and snap it into place.
  2. Route the cables through the routing guides on the front I/O-panel.
  3. Replace the four screws (M3x4) that secures the front I/O-panel to the front bezel.

Next steps

  1. Install the front bezel.
  2. Install the right-side cover.
  3. Install the left-side cover.
  4. Install the top cover.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\