Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Alienware Aurora R11 Service Manual

Installing the power-button board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the power-button board and provides a visual representation of the installation procedure.

Image: Installing the power-button board

Steps

  1. Align the screw holes on the power-button module with the screw holes on the front bezel.
  2. Replace the two screws (M2x4) that secure the power-button module to the front bezel.
  3. Connect the cables to the power-button module.

Next steps

  1. Install the front bezel.
  2. Install the top-cover.
  3. Install the right-side cover.
  4. Install the left-side cover.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\