- Notes, cautions, and warnings
- Introduction to Dell Command | Configure 4.10
- Windows SMM Security Mitigations Table (WSMT) Compliance for Dell Command | Configure 4.10
- Using user interface for Dell Command | Configure 4.10
- Accessing Dell Command | Configure within Windows system
- Accessing Dell Command | Configure within Linux
- Files and folders of Dell Command | Configure
- Accessing the Dell Command | Configure GUI
- Creating a BIOS package using the GUI
- Configure the general settings
- Configuration options
- Configuring the setup, system, and hard disk drive passwords
- Clearing setup, system and hard disk drive passwords using the existing password
- Password protection screen
- Configuring the autoon option
- Configuring the BIOSConnect profiles
- Configuring the bootorder option
- Boot order screen
- Adding a new device to the boot order
- Boot order type
- Configuring the primarybatterycfg option
- Configuring the advbatterychargecfg option
- Configuring the peakshiftcfg option
- Password Configuration option
- Configuring the keyboardbacklightcolor option
- Advanced System Management
- BIOS option validation
- Exporting the BIOS configuration
- Target system configuration
- Log details in Package History
- Troubleshooting scenarios in Dell Command | Configure 4.10
Dell Command | Configure Version 4.10 User's Guide
What’s new in this release
- Added support for Ubuntu 22.04 LTS operating system.
- Added support for the following BIOS attributes:
- NumaNodesPerSocket
- CameraShutterStatus
- Fixed the issue where Dell Command | Configure adds extra spaces while setting AssetTag value.
- Fixed the issue where Dell Command | Configure is unable to configure value for FanSpdAutoLvlonPcieZone BIOS setting.
- Fixed the issue where Dell Command | Configure does not get correct memory size for size greater or equal to 32 GB.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\