Clearing setup, system and hard disk drive passwords using the existing password
You can clear the configured setup, system, and hard disk drive passwords using the existing password.
NOTE:It is not possible to clear the password without knowing the existing password.
To clear the passwords:
In the
Edit mode, click the
Value to Set
text box of the required option.
The corresponding password screen is displayed.
NOTE:To display the password as clear text, select
Show Password. If you select
Show Password, then the
Confirm Password
text box is not displayed.
Enter a blank space in the
Password
text box.
Enter a blank space in the
Confirm Password
text box to confirm the password.
If both the entries match, a green check mark is displayed next to the
Confirm Password
text box. A red X mark is displayed if both entries do not match.