Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Configuration Guide for the S4048–ON System 9.14.2.6

PDF

Assigning a Front-end Port to a Management VRF

Starting in 9.7(0.0) release, you can assign a front-end port to a management VRF and make the port to act as a host interface.
NOTE You cannot assign loop-back and port-channel interfaces to a management port.

To assign a front-end port to a management VRF, perform the following steps:

  1. Enter the front-end interface that you want to assign to a management interface.
    CONFIGURATION
    interface tengigabitethernet 1/1
  2. Assign the interface to management VRF.
    INTERFACE CONFIGURATION
    ip vrf forwarding management
    Before assigning a front-end port to a management VRF, ensure that no IP address is configured on the interface.
  3. Assign an IPv4 address to the interface.
    INTERFACE CONFIGURATION
    ip address 10.1.1.1/24
    Before assigning a front-end port to a management VRF, ensure that no IP address is configured on the interface.
  4. Assign an IPv6 address to the interface.
    INTERFACE CONFIGURATION
    ipv6 address 1::1
    You can also auto configure an IPv6 address using the ipv6 address autoconfig command.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\