Dell Configuration Guide for the S4048–ON System 9.14.2.6

Assigning OSPFv3 Process ID and Router ID to a VRF

To assign, disable, or reset OSPFv3 on a non-default VRF, use the following commands.

• Enable the OSPFv3 process on a non-default VRF and enter OSPFv3 mode.
  CONFIGURATION mode
  ipv6 router ospf {process ID}}
  The process ID range is from 0 to 65535.
• Assign the router ID for this OSPFv3 process.
  CONF-IPV6-ROUTER-OSPF mode
  router-id {number}
  • number: the IPv4 address.
  The format is A.B.C.D.
  NOTE Enter the router-id for an OSPFv3 router as an IPv4 IP address.
• Disable OSPF.
  CONFIGURATION mode
  no ipv6 router ospf process-id vrf {vrf-name}
• Reset the OSPFv3 process.
  EXEC Privilege mode
  clear ipv6 ospf [vrf vrf-name] process