PowerProtect Data Manager 19.11 Kubernetes User Guide

PDF

Supported Internet Protocol versions

PowerProtect Data Manager only supports the use of IPv4 addresses.

Using an IPv6 address can result in errors or other unexpected behavior. When configuring devices to connect over the network with PowerProtect Data Manager, use only IPv4 addresses.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\