You can install the iDRAC Service Module silently
in the background without a user console. This can be achieved by
using setup.sh with parameters.
The parameters that can be passed to use setup.sh are:
Table 1. Silent installationThe following table provides information about the
parameters used for silent installation of iDRAC Service Module.
Parameter
Description
-h
Help: Displays the help
-I
Install: Installs and enables the selected features
-x
Express: Installs and enables all available features.
-d
Delete: Uninstall the iDRAC Service Module component
-w
Automatic System Recovery: Enables the Automatic
System Recovery Instrumentation Service
-I
LC LOG: Enables the Lifecycle Log Replication
-o
OS Information: Enables the Operating System Information
-a
Autostart: Start the installed service after the
component has been installed
-O
iDRAC access via Host OS: Enables the iDRAC access
via Host OS feature
NOTE: On Linux operating systems, if a feature modifying operation
with silent option is enabled from the Linux webpack (using setup.sh),
then the previously enabled feature states will be overridden by the
new features select during modifying operation.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\