- Notes, cautions, and warnings
- Introduction to this guide
- Planning an upgrade
- Completing pre-upgrade tasks
- Pre-upgrade process - Overview
- Collect cluster information
- Check cluster readiness
- Verify configurations and settings
- Download the OneFS installation bundle file
- Upgrade compatibility check utility
- On-Cluster Analysis tool
- HealthCheck tool
- Backup data
- Complete or stop jobs in progress
- Update Node Firmware Package
- Update Drive Support Package
- Configure IPMI ports
- Disable SupportAssist or Secure Remote Services (SRS)
- Performing the OneFS upgrade
- Upgrade process overview
- Completing a parallel upgrade of OneFS
- Completing a rolling upgrade of OneFS
- Completing a simultaneous upgrade of OneFS
- Adding a node to the cluster while an upgrade is in progress
- Committing an upgrade of OneFS
- Rolling back an upgrade of OneFS
- Verify the OneFS installation using the CLI
- Completing post-upgrade tasks
- Troubleshooting your upgrade
PowerScale OneFS Upgrade Planning and Process Guide
Test custom scripts
Test any custom scripts you have implemented to confirm they continue to work. If command syntax changes were made in the target version of
OneFS, some custom scripts might not work as intended.
NOTE:It is recommended to ensure that your custom scripts work on a test cluster before implementing them on a production system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\