- Notes, cautions, and warnings
- Introduction to this guide
- Planning an upgrade
- Completing pre-upgrade tasks
- Pre-upgrade process - Overview
- Collect cluster information
- Check cluster readiness
- Verify configurations and settings
- Download the OneFS installation bundle file
- Upgrade compatibility check utility
- On-Cluster Analysis tool
- HealthCheck tool
- Backup data
- Complete or stop jobs in progress
- Update Node Firmware Package
- Update Drive Support Package
- Configure IPMI ports
- Disable SupportAssist or Secure Remote Services (SRS)
- Performing the OneFS upgrade
- Upgrade process overview
- Completing a parallel upgrade of OneFS
- Completing a rolling upgrade of OneFS
- Completing a simultaneous upgrade of OneFS
- Adding a node to the cluster while an upgrade is in progress
- Committing an upgrade of OneFS
- Rolling back an upgrade of OneFS
- Verify the OneFS installation using the CLI
- Completing post-upgrade tasks
- Troubleshooting your upgrade
PowerScale OneFS Upgrade Planning and Process Guide
Update Node Firmware Package
Before upgrading your OneFS cluster, ensure that your nodes are running the most recent version of firmware found in the Node Firmware Package.
For additional information on updating node firmware, see the
OneFS Node Firmware Package site.
NOTE:In OneFS 9.2.0.0 and later, you can choose to update the Node Firmware Package during a parallel upgrade. If you choose to perform the Node Firmware update during an upgrade, delay this step until the
Performing a Parallel Upgrade chapter.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\