- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Disassembly and reassembly
- Subscriber Identity Module(SIM) board
- SD card—optional
- Base cover
- Battery
- SSD card–optional
- SSD frame
- Hard drive
- Coin-cell battery
- WLAN card
- WWAN card – optional
- Memory modules
- Keyboard lattice and Keyboard
- Heat sink
- System fan
- Power connector port
- Chassis frame
- LED board
- SmartCard module
- Touchpad panel
- System board
- Speaker
- Display hinge cover
- Display assembly
- Display bezel
- Display panel
- Display (eDP) cable
- Camera
- Display hinges
- Display back cover assembly
- Palm rest
- Troubleshooting
- Getting help
Latitude 5491 Service Manual
Installing the SSD card
NOTE: The following procedure applies for SATA M.2 2280 and PCIe M.2 2280
- Insert the SSD card into the connector on the system.
- Replace the M2*3 screw that secures the SSD card to the system.
- Place the Mylar shield over the SSD.
- Install the :
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\