The RAIDCFG.BAT or raidcfg.sh sample script configures RAID controllers detected
on the system. User input is optional to run this script. The input
parameter is a name or path to a log file. This parameter is not set
to any value by default, and no log file is generated. The default
variable values used in this script are set in the TKENVSET.BAT or tkenvest.sh scripts. This script uses the RAIDCFG.EXE or raidcfg.sh utility
to automatically configure the detected controllers on your target
system. For example, for the first controller discovered, if RAIDCFG.EXE or raidcfg.sh discovers
only one attached hard drive, the script tries to create RAID 0; if
two hard drives are discovered, a RAID 1 configuration is enabled;
if three or more hard drives are discovered, a RAID 5 configuration
is enabled.
NOTE: On the detected
controller, a RAID virtual disk is created only if the array disks
connected to that particular controller have space available and,
where applicable, are not part of existing array group.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\