- Notes, cautions, and warnings
- Introduction to Power Manager
- What is new in this release
- Compatibility matrix
- License requirements
- Scalability and performance
- Getting started with Power Manager
- Monitoring and managing Power Manager metrics
- Rack management
- Manage data center during power reduction
- Quick access to Power Manager data
- Adding or removing groups from OpenManage Enterprise dashboard to monitor Power Manager data
- View power and thermal history of Power Manager groups
- Viewing top five energy consumers
- Viewing ratio of devices discovered in OpenManage Enterprise to devices added in Power Manager
- View top ten power offenders
- View top ten temperature offenders
- View top 10 underutilized racks for power and space
- View power and space headroom
- Maintaining Power Manager
- Alerts
- Reports in Power Manager
- Updating Power Manager
- Frequently Asked Questions
- Troubleshooting
- Other information you may need
Dell EMC OpenManage Enterprise Power Manager Version 1.2 User’s Guide
Disabling Emergency Power Reduction
To restore the devices or groups to their normal state, disable the Emergency Power Reduction (EPR).
About this task
NOTE An EPR activated due to temperature-triggered event cannot be disabled manually. After the temperature reduces to the normal value,
Power Manager automatically removes the EPR.
To disable a manually applied EPR, perform the following steps:
Steps
- Launch OpenManage Enterprise.
-
If you are using OpenManage Enterprise version 3.4 or earlier, click
.
If you are using OpenManage Enterprise version 3.5 or earlier, click .
-
Select the devices or groups for which you want to disable EPR, and click
Disable.
In the confirmation page, click Yes.EPR is disabled successfully.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\