Hardware inventories of the following target node components are displayed:
System
Firmware
CPUs
Accelerators
Memory
Storage Controllers
To view the physical disks in a storage controller, under
Related Disks, click the
View Disks link. The physical disks are listed in the
Physical Disks tab.
Storage Enclosures
Network Devices
Physical Disks
To view the additional properties of a disk, select the disk, and then click
Advanced Properties. To view the associated storage controller, click the storage controller link under
Advanced Properties. The associated storage controller is displayed in the
Storage Controllers tab. If physical disks are attached to the CPU, then the storage controller link will not be available under
Advanced Properties.
To blink and unblink the physical disks
Select a physical disk, click
Blink to enable the blinking of the LEDs on the physical disk. The LEDs represent the state of physical disks. When the physical disks are blinking, it helps to locate and also to identify the faulty physical disks in your data center. To disable the blinking of the physical disks, select a disk and click
Unblink.
NOTE: The blink and unblink operations are not available for:
Disks associated to Boot Optimized Storage Subsystem (BOSS) cards.
Devices with iDRAC firmware version less than 3.30.30.30. Update the iDRAC firmware to the latest version to enable blink and unblink operations.
NOTE:
When the blink or unblink operation is running,
Refresh button to load the latest health and hardware inventory information is disabled. Also, when the health and hardware inventory is being loaded in OMIMSWAC, blink and unblink operations is disabled.
Blink or unblink operation fails on physical disks that are attached to an embedded SATA controller with an error
Blink/Unblibk May not be supported with - <disk_name>.
Power Supplies
Fans
To view the latest hardware inventory information, in the upper-right corner of the
Inventory tab, click
Refresh.
NOTE: Under
Inventory, the attribute values of a few target node components are displayed as blank because the value might not be available in the target node.
NOTE: Under Firmware inventory, for few network devices with multiple ports, since the applicable firmware version is same for all ports, only a single port with the firmware version will be displayed.
NOTE: Information of few attributes of storage enclosures, firmware inventory, and memory component might not be available for:
YX2X and YX3X models of PowerEdge servers.
YX4X models of PowerEdge servers with iDRAC version lesser than 3.30.30.30.
NOTE: For PCIe SSD Backplane of storage enclosures, few attribute values might not be available.
NOTE: Health status information is available for Accelerators in YX4X models of PowerEdge servers and above with iDRAC version 4.00.00.00 or newer.
NOTE: Intel
DIMM memory is identified as
IntelPersistent with an icon.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\