- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of OptiPlex 3000 Small Form Factor
- Side cover
- Front bezel
- Intrusion switch
- Hard drive
- Disk-drive cage
- Optical drive
- Solid-state drive
- Bay-support bracket
- Coin-cell battery
- Power button
- WLAN card
- WLAN antenna
- WLAN antennas (External)
- Memory
- Fan assembly
- Processor heat-sink assembly
- Processor
- Expansion card
- Optional I/O modules (PS2/Serial)
- Optional I/O modules (VGA/HDMI/DP)
- Speakers
- Power-supply unit
- System board
- Drivers and downloads
- Getting help and contacting Dell
OptiPlex 3000 Small Form Factor Service Manual
Removing PS2 module
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the side cover.
- Remove the front bezel.
- Remove the fan assembly.
About this task
The following images indicate the location of the PS2 module and provide a visual representation of the removal procedure.
Steps
- Lift the pull tab and open the expansion-card door.
- Disconnect the PS2 module cable from the connector on the system board.
- Lift the PS2 module off the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\