OptiPlex 3050 Tower Owner's Manual

Installing VGA daughter board

1. To remove the metal bracket as shown below, insert a flathead screwdriver in the hole of the bracket and push the bracket to release the bracket, and then lift the bracket out from the system.
   
2. Insert the VGA connector into the slot from inside of the computer [1].
3. Tighten the screws to secure the VGA connector to the computer [2].
   
4. Align the VGA daughter board with the screw holder on the system board [1].
5. Tighten the screw to secure the VGA daughter board to the system board [2].
   
6. Close the front panel door.
7. Install the:
   1. bezel
   2. cover
8. Follow the procedure in After working inside your computer.