OptiPlex 5000 Micro Service Manual

Screw list

NOTE:When removing screws from a component, it is recommended to note the screw type and the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.

NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component.

NOTE:Screw color may vary depending on the configuration ordered.

Table 1. Screw listThe following table provides the different screws that are used in your OptiPlex 5000 Micro.
Component	Screw type	Quantity	Image
Side cover	6x32 (Thumb Screw)	1
M.2 2230/2280 solid-state drive	M2x3.5	1
WLAN-card bracket	M2x3.5	1
Heat sink	M3x25 (Captive screws)	3
Optional I/O module (Type C)	M2x3	2
Optional I/O modules (HDMI/VGA/DP)	M2x3	2
Optional I/O module (Serial)	M2x5	2
Internal antenna	M3x3MM Captive Screw (optional)	1 1
Speaker support bracket	M3x5	1
System board	M3x5 M3x4L	5 2