Dell OptiPlex 5270 All-in-One Service Manual

Installing the pop-up camera

1. Follow the procedure in After working inside your computer.
2. To install the pop-up camera module:
   1. Replace the camera module along with the camera cable in the slot on the pop-up camera assembly [1].
   2. Snap the pop-up camera assembly in place to the tab [2].
      
3. To install the pop-up camera bezel:
   1. Align the screw slots on the pop-up camera bezel with the screw slots on the pop-up camera assembly [1].
   2. Replace the three screws (M3x5) that secure the pop-up camera bezel to the pop-up camera assembly [2].
   3. To retract the pop-up camera, press the top of the pop-up camera assembly[3].
   
4. To install the pop-up camera assembly:
   1. Route the camera cable through to the routing channel [1].
   2. Align and place the pop-up camera assembly on the display panel base [2].
   3. Replace the two screws (M3x5) that secure the pop-up camera assembly to the middle frame [3].
      
5. To replace the camera assembly cover:
   1. Connect the camera cable to the system board [1].
   2. Align and place the pop-up camera assembly cover on the middle frame [2].
   3. Replace the two screws (M3x5) that secure the camera assembly cover to the middle frame [3].
      
6. Install the following components:
   1. System board shield
   2. Back cover
   3. Stand