Dell OptiPlex 5270 All-in-One Service Manual

Removing the pop-up camera

1. Follow the procedure in Before working inside your computer.
2. Remove the following components:
   1. Stand
   2. Back cover
   3. System board shield
3. To remove the camera assembly cover:
   1. Remove the two screws (M3x5) that secure the camera assembly cover to the middle frame [1].
   2. Lift the camera assembly cover away from the middle frame [2].
   3. Disconnect the camera cable from the system board [3].
      
4. To remove the pop-up camera assembly:
   1. Remove the two screws (M3x5) that secure the pop-up camera assembly to the middle frame [1].
   2. Slide the pop-up camera assembly forward [2].
   3. To remove the pop-up camera assembly off the middle frame, unroute the camera cable from the routing channel [3].
      
5. To remove the pop-up camera bezel:
   1. Press the top of the pop-up camera assembly to extend the pop-up camera.
   2. Remove the three screws (M3x5) that secure the bezel to the pop-up camera assembly [2].
   3. Lift the pop-up camera bezel off the pop-up camera assembly [3].
      
6. To remove the pop-up camera module:
   1. Release the camera module from the tab [1].
   2. Remove the camera module along with the camera cable off the pop-up camera assembly [2].