Rotate
the I/O panel and remove it from the system [2].
Disconnect the hard drive data cable [3], optical drive data
cable [4] and power cable [5] from the connectors on the system board.
Disconnect the following cables from the connectors on the system
board:
Intrusion switch [1]
CPU power [2]
Power cable [3]
Power switch [4]
Unroute the
PSU cables from the retention clips [5].
To remove the screws from the system board:
Remove the screws (5) that secure the system board to the chassis [1].
Remove the single screw
used as a mounting point for M.2 SSD drive [2] and the standoff single (#6-32) screw [3] that secures the system board to the system [3].
To remove the system board:
Lift and slide the system board away from the system [1, 2].
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\