Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R630 Owner's Manual

PDF

Installing the control panel–10 hard drive system and 24 hard drive system

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Keep the Philips #1 screwdriver ready.

Steps

  1. Route the control panel cable through the chassis and connect the control panel cable to the control panel.
  2. Push the control panel into the chassis till it snaps into place.
    NOTE Ensure that the screw hole on the control panel aligns with the screw hole located at the top of the chassis.
  3. Replace the screw that secures the control panel to the chassis.
  4. Locate the connectors J_CP and J_FP_USB on the system board.
    NOTE To locate the connectors on the system board, see the Jumpers and connectors section.
  5. Connect the control panel cable to the connectors on the system board (J_CP and J_FP_USB) and the hard drive expander card.
    NOTE Ensure that the control panel cable inside the system is routed along the chassis wall and secured by using the cable securing bracket.
    Figure 1. Installing the control panel for 10 and 24 hard drive system
    The figure shows installing the control panel for 10 and 24 hard drive system.
    1. control panel
    2. screw hole on the control panel
    3. screw hole on the chassis
    4. screw
    5. cable securing clip
    6. J_CP connector on the system board
    7. J_FP_USB connector on the system board

Next steps

Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\