Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge R630 Owner's Manual

Removing the control panel–10 hard drive and 24 hard drive system

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the Philips #1 screwdriver ready.

Steps

  1. Remove the screw (located at the top of the chassis) that secures the control panel to the chassis.
  2. Remove the control panel cable from the connectors on the system board (J_CP and J_FP_USB) and the hard drive expander card.
    NOTE To locate the connectors on the system board, see the System board connectors section.
  3. Slide the control panel out of the chassis.
  4. Disconnect the control panel cable from the control panel.
    Figure 1. Removing the control panel for 10 and 24 hard drive system
    The figure shows removing the control panel for 10 and 24 hard drive system.
    1. control panel
    2. screw hole
    3. screw
    4. cable securing clip
    5. J_CP connector on the system board
    6. J_FP_USB connector on the system board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\