Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge R720 and R720xd Owner's Manual

Removing The Internal Dual SD Module

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  2. Open the system.
  3. Remove the expansion-card riser 3 and any card(s) installed in the riser.
  4. Locate the internal dual SD module installed on the J_IDSDM connector on the system board.
  5. If applicable, remove the SD card(s).
  6. Holding the tab, pull the dual SD module to remove it from the system board.
  7. Replace the expansion-card riser 3 and if applicable, replace the card(s) in the riser.
  8. Close the system.
  9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
    Figure 1. Removing and Installing the Internal Dual SD Module The figure shows removing and installing the internal dual SD module.
    1. blue pull tab
    2. SD card 1
    3. SD card 2
    4. dual SD module
    5. connector on the system board

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\