Under Storage Configuration wizards, click Key Encryption.
Select the controller to apply a local key and click Next.
Click Set up local key encryption and click Next.
NOTE: Some controller options
are disabled if they do not support encryption.
Enter the Encryption Key Identifier that is associated with the entered passphrase.
The Encryption Key Identifier is a passphrase hint; you must
enter the passphrase when Lifecycle Controller prompts this hint.
In the New Passphrase field, enter
a passphrase.
NOTE: The controller uses
the passphrase to encrypt the disk drive data. A valid passphrase
contains 8–32 characters. It must include a combination of uppercase
and lowercase letters, numbers, and symbols without spaces.
In the Confirm Passphrase field,
re-enter the passphrase, and then click Finish.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\