Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Installing the internal cooling fan

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. If installed, remove the front bezel.

Steps

  1. Hold the cooling fan by the sides with the cable end facing the bottom of the system.
  2. Align the four tabs on the internal cooling fan with the four slots on the system wall.
  3. Press and slide the internal cooling fan into the slots until the release tab locks into place.
  4. Connect the internal cooling fan power cable to the connector on the system board.
    Figure 1. Installing the internal cooling fan
    This image shows how to install an internal cooling fan

Next steps

  1. Install the air shroud.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\