Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge T440 Installation and Service Manual

PDF

System health and system ID indicator codes

The system health and system ID buttonSystem identification icon is on the front panel of your system.

Figure 1. System health and system ID buttons

This image shows system health and system ID indicators.

Table 1. System health and system ID indicator codesThis table describes the system health and system IDbutton indicators. Item 1 indicates Solid blue where the condition indicates that the system is turned on, system is healthy, and system ID mode is not active. Press the system health and system ID button to switch to system ID mode. Item 2 indicates Blinking blue where the condition indicates that the system ID mode is active. Press the system health and system ID button to switch to system health mode. Item 3 indicates solid amber where the condition indicates that the system is in fail-safe mode. If the problem persists, see the Getting help section. Item 4 indicates blinking amber where the condition indicates that the system is experiencing a fault. Check the System Event Log or the LCD panel, if available on the bezel, for specific error message. For information about the event and error messages generated by the system firmware and agents that monitor system components, go to qrl.dell.com > Look Up > Error Code, type the error code, and then click Look it up.
System health and system ID indicator codeCondition
Solid blue Indicates that the system is turned on, system is healthy, and system ID mode is not active. Press the system health and system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health and system ID button to switch to system health mode.
Solid amberIndicates that the system is in fail-safe mode. If the problem persists, see Getting help.
Blinking amber Indicates that the system is experiencing a fault. Check the System Event Log for specific error messages. For information about the event and error messages generated by the system firmware and agents that monitor system components, go to qrl.dell.com > Look Up > Error Code, type the error code, and then click Look it up.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\