Dell EMC PowerEdge T440 Installation and Service Manual

Removing the control panel assembly

1. Using the Phillips #2 screwdriver, remove the screw that secures control panel to the chassis.
2. Disconnect the control panel cable and the control panel USB cable from the system board.
   CAUTION Do not use excessive force when removing the control panel cables as it can damage the connectors.
3. Slide the control panel out of the chassis.
   NOTE Follow the same steps to remove the control panel in the rack-mode configuration.

   

4. To remove the information tag, perform the following steps:
   1. Locate and press the tabs on the information tag.
   2. Push the information tag out of the slot to remove it from the control panel.
      NOTE Retain the information tag to replace it in the new control panel.