Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Installing the system feet

Prerequisites

CAUTION Install the feet on a stand-alone tower system to provide stability to the system. An unstable system might tip over and cause injury to the user or damage to the system.
  1. Follow the safety guidelines listed in Safety instructions.
  2. Place the system on its side, on a flat, stable surface.

Steps

  1. Align the three tabs on the system foot with the three slots on the base of the system.
  2. Using the Phillips #2 screwdriver, secure the screw that secures the foot to the base of the system.
    1. Repeat the above steps to install the remaining system feet.
    Figure 1. Installing the system feet
    This image shows installing the system feet

Next steps

  1. Place the system upright on a flat, stable surface, and rotate the system feet outward.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\