- Notes, cautions, and warnings
- Dell EMC PowerEdge T440 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System feet
- Inside the system
- Caster wheels – optional
- System cover
- Air shroud
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Installing a drive carrier
- Removing the drive from the drive carrier
- Installing a drive into the drive carrier
- Removing a 2.5-inch drive from a 3.5-inch drive adapter
- Installing a 2.5-inch drive into a 3.5-inch drive adapter
- Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
- Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
- Optical drives and tape drives
- Cabled drives
- Drive backplane
- System memory
- Cooling fans
- Optional internal USB memory key
- Expansion card holder
- Expansion cards
- M.2 SSD module
- Optional MicroSD or vFlash card
- Optional IDSDM or vFlash module
- Processors and heat sinks
- Power supply units
- Power interposer board
- System battery
- Control panel assembly
- System board
- Trusted Platform Module
- Converting the system from tower mode to rack mode
- Updating BIOS
- Jumpers and connectors
- System diagnostics
- Getting help
- Documentation resources
Dell EMC PowerEdge T440 Installation and Service Manual
System board jumpers and connectors
| Item | Connector | Description |
|---|---|---|
| 1 | DIMMs for Processor 1 channels 0,1,2,3,4,5 | Memory slots A1-A10 for Processor 1 |
| 2 | Intrusion switch | Intrusion switch connector |
| 3 | SATA B | Onboard SATA B connector |
| 4 | Backplane signal | Backplane signal connector |
| 5 | Front_USB | Front USB connector |
| 6 | SATA connector | SATA connector |
| 7 | Control panel | Control panel connector |
| 8 | ODD power | ODD power connector |
| 9 | System power | System power connector |
| 10 | PIB signal 2 | PIB signal 2 connector |
| 11 | IDSDM+VFlash | IDSDM+VFlash connector |
| 12 | PIB signal 1 | PIB signal 1 connector |
| 13 | SATA A | SATA A connector |
| 14 | Internal USB 3.0 | Internal USB 3.0 connector |
| 15 | COIN Cell BATTERY | Coin cell battery |
| 16 | NVRAM_CLR | Clear NVRAM |
| 17 | PWRD_EN | Reset BIOS password |
| 18 | PCIe slots | PCIe slots 1 - 5 |
| 19 | TPM | TPM connector |
| 20 | Fan 1 | Internal fan connector |
| 21 | Fan 2 | External fan connector |
| 22 | DIMMs for Processor 2 channels 0,1,2,4,5 | Memory slots B1-B6 for Processor 2 |
| 23 | Processor 2 | Processor 2 |
| 24 | Processor 2 PWR | Processor 2 Power connector |
| 25 | Processor 1 | Processor 1 |
| 26 | Processor 1 PWR | Processor 1 Power connector |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\