Perform the following steps to configure FC ports:
In the Welcome panel, select
System Settings, and then click the
Ports tab.
On the
Port Settings tab, set the port-specific options:
Set the
Speed option to the proper value to communicate with the host, or to auto, which auto-negotiates the proper link speed. Because a speed mismatch prevents communication between the port and host, set a speed only if you need to force the port to use a known speed.
Set the
Connection Mode to either point-to-point or auto:
point-to-point – Fibre Channel point-to-point.
auto – Automatically sets the mode based on the detected connection type.
Perform one of the following:
To save your settings and continue configuring your system, click
Apply.
To save your settings and close the panel, click
Apply and Close.
A confirmation panel appears.
Click
OK.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\