Dell Precision 3930 Rack Service Manual

Installing the riser 1 dell ultraspeed drive duo card

1. Press the release latch on the dell ultraspeed drive duo card cover [1] and lift the cover open [2]. Remove the one (M2x2.5) screw [3].
   
2. To install the M.2 SSD
   1. Insert the SSD card into the slot on the module [1], Replace the one (M2x2.5) screw [2] that secures the SSD card and close the module cover [3].
      
3. Slide the Dell Ultraspeed Drive Duo Card into the riser 1 slot 2 [1]. Close the riser 1 module release latch [2].
   NOTE: Ensure that the Dell Ultraspeed Drive Duo Card bracket is installed correctly in the slot.
   
4. Install the:
   1. Riser 1 module
   2. Top cover
5. Follow the procedure in After working inside your computer.