Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Dell Precision 5820 Tower Owner's Manual

Power management

Table 1. Power ManagementThe table describes the power management options.
Option Description
AC Recovery

Specifies how the computer will respond when AC power is applied after an AC power loss.

You can set the AC Recovery to:
  • Power Off—Default
  • Power On
  • Last Power State
Auto On Time

Allows you to set the time at which the computer must turn on automatically.

Click one of the following options:
  • Disabled—Default
  • Every Day
  • Weekdays
  • Select Days
Deep Sleep Control

Allows you to define the controls when Deep Sleep is enabled.

Click one of the options:
  • Disabled—Default
  • Enabled in S5 only
  • Enabled in S4 and S5
Fan Speed Control

Allows you to control the speed of the system fan.

Click one of the options:
  • Low
  • Auto—Default
NOTE:Low = Fans run low and quite. System performance may decrease.

Auto = Fans run at optimal speed based on environmental data. System performance is maximized.

USB Wake Support

Allows you to enable USB devices to wake the system from standby.

  • Enable USB Wake Support

This option is set by default.

Wake on LAN

This option allows the computer to power up from the off state when triggered by a special LAN signal. Wake-up from the Standby state is unaffected by this setting and must be enabled in the operating system. This feature only works when the computer is connected to AC power supply.

  • Disabled - Does not allow the system to power on by special LAN signals when it receives a wake-up signal from the LAN or wireless LAN.
  • LAN Only - Allows the system to be powered on by special LAN signals.
  • LAN with PXE Boot - Allows the system to power on and immediately boot to PXE when it receives a wake-up packet sent to the system in either the S4 or S5 state.

All the options are not set by default.

Block Sleep Allows you to block entering to sleep(S3 state) in OS Environment.

This option is not set by default.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\