SC460 Expansion Enclosure Owner's Manual

Follow these best practice guidelines when installing the SC460 expansion enclosure in a non-standard rack:

• A non-standard rack might have PDUs that face into the rack. This might cause interference between the expansion enclosure and/or rear cable management arms (if used). Carefully plan and route cables to minimize any interference. It might be necessary to use a different type of PDU that is mounted in the main rack area.

• The rack rails have four adjustment ranges, 18-22", 22-26", 26-30", 30-34". The default length is the 22-26" setting.
• After installing a rail, check the rail to make sure that it is level and in the correct location before installing the next rail.
• Use the M5 screws, which align with both round and square holes, to secure all rails and components in the rack.
• When securing rails to a rack, install the screws loosely to prevent cross threading, and tighten by hand. Do not over torque.