Perform these steps to power up the Storage Center hardware after powering
off the hardware or after a power outage.
About this task
If the Storage Center hardware includes expansion enclosures, turn on the expansion enclosures first, then
turn on the storage system.
Steps
Connect the storage system and any expansion enclosures to a power
source.
Turn on any expansion enclosures attached to
the Storage Center.
NOTE After an expansion enclosure is
powered on, its ID number is displayed on the back panel. If you want
the expansion enclosures IDs
to appear in sequential order, turn on each expansion enclosure one at a time, in
the order that you want the IDs to appear.
Press both power switches on the back of
the expansion enclosure at the same
time to turn on the expansion enclosure.
The status indicator on the front of the expansion enclosure turns blue when the expansion enclosure is powered up and
operational.
Power on any additional expansion enclosures attached to
the Storage Center, waiting for
each expansion enclosure to become
operational before turning on the next expansion enclosure.
After all the expansion enclosures are powered
on, turn on the storage system by
pressing both power switches on the back of the chassis.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\