Always follow these safety precautions to avoid
injury and damage to Storage Center equipment.
If equipment
described in this guide is used in a manner not specified by Dell
, the protection
provided by the equipment could be impaired. For your safety and protection,
observe the rules described in the following sections.
NOTE See the safety and
regulatory information that shipped with each Storage Center component. Warranty
information is included as a separate document.
Installation Safety
Precautions
Follow these safety precautions when installing an SC7020 series storage system:
Dell
recommends that
only individuals with rack-mounting experience install an SC7020 series storage system in a rack.
When installing multiple expansion enclosures in a rack, fill the rack from the bottom
up and empty the rack from the top down.
The rack construction must support
the total weight of the installed expansion enclosures. The
design should incorporate stabilizing features suitable to prevent
the rack from tipping or being pushed over during installation or
in normal use.
To prevent the rack from tipping, slide
only one storage system out of the rack at a time.
Make sure that the storage system is always fully grounded to prevent damage
from electrostatic discharge.
When handling the storage system components,
use an electrostatic wrist guard or a similar form
of protection.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\