SCv3000 and SCv3020 Storage System Owner’s Manual

Use this procedure to install riser 1.

1. Use the alignment pegs on the board and the alignment casings on the riser to position the riser over the connector.
2. Lower the riser into place until the riser is fully seated in the connector.
3. Lower the blue latch to secure the riser to the chassis.
4. Replace the cover on the storage controller.
5. Remove the service baffle from the chassis.
   • CAUTION: To prevent a thermal shutdown of the storage system, the storage controller must be installed within three minutes of removing the service baffle.
6. Install the storage controller into the chassis.
7. Reconnect the cables to the storage controller.
8. Clear the storage controller swap status from the Hardware tab in Dell Storage Manager . For instructions, see the Storage Manager Administrator’s Guide .