- Notes, cautions, and warnings
- Working on your computer
- Disassembly
and reassembly
- Recommended tools
- Screw list
- Base cover
- Battery
- WLAN card
- Memory modules
- Solid-state drive
- Hard drive
- Speakers
- Graphics Processing Unit (GPU) fan
- CPU fan
- Heat sink
- Coin-cell battery
- I/O board
- Power button with optional fingerprint reader
- Power-adapter port
- Touchpad
- Display assembly
- Display bezel
- System board
- Palmrest assembly
- Software
- System setup
- Troubleshooting
- Getting help
Vostro 7590 Service Manual
Installing the display assembly
Prerequisites
About this task
The figure indicates the location of the component and provides a visual representation of the installation procedure.
Steps
- Place the display assembly on a clean and flat surface.
- Align and place the palm-rest and keyboard assembly on the display assembly.
- Using the alignment posts, close the display hinges.
- Replace the three screws (M2.5x5) that secure the left-display hinge to the system board.
- Replace the three screws (M2.5x5) that secure the right-display hinge to the system board.
- Connect the display cable on to the connector on the system board and adhere the tape to the system board.
Next steps
- Install the WLAN card.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\