Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Vostro 7590 Service Manual

PDF

Installing the system board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the system board and provides a visual representation of the installation procedure.

Image: Installing the system board

Image: Installing the system board

Image: Installing the system board

Steps

  1. Slide the ports on the system board into the slots on the palm-rest and keyboard assembly and align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
  2. Replace the six screws (M2x4) that secure the system board to the palm-rest and keyboard assembly.
  3. Connect the display cable on to the connector on the system board.
  4. Adhere the tape that secures the display cable to the system board.
  5. Replace the two screws (M2x5) that secure the USB Type-C port bracket to the system board.
  6. Connect the keyboard-backlight cable to the system board and close the latch to secure the cable.
  7. Connect the touchpad cable to the system board and close the latch to secure the cable.
  8. Connect the speaker cable to the system board.
  9. Connect the power-adapter cable to the system board.
  10. Connect the I/O-board cable to the system board and close the latch to secure the cable.

Next steps

  1. Install the display assembly.
  2. Install the memory module.
  3. Install the heat sink.
  4. Install the left-side fan.
  5. Install the right-side fan.
  6. Install the WLAN card.
  7. Install the M.2 2230 solid-state drive.
  8. Install the M.2 2280 solid-state drive.
  9. Install the battery.
  10. Install the base cover.
  11. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\